Traxxas X-Maxx 4WD Brushless TQi TSM
TRX77076-4     




9995 kr

                Köp antal




Beställningsvara. Leveranstid 2-5 dagar.

Produkten kan fn. ej köpas




Biltyp: Monster Truck
Driftsätt: El
Drivning: 4WD
Levereras som: RTR (Ready-To-Run)
Lämplig för: Nybörjare, Erfaren
Skala: 1/8 XL, 1/8
Längd: 758 mm
Bredd: 540 mm
Höjd: 350 mm
Markfrigång: 102 mm
Vikt: 8660 g
Fartreglage: Traxxas Velineon VXL-6s
Sändare: Traxxas TQi 3-Kanal (Bluetooth Link)
Toppfart: 55 km/h
Motor: Traxxas Velineon 1600XL
Motortyp: Borstlös
Batteri: Ingår Ej
Vattenskyddad: Ja
Behöver kompletteras med: 4st AA batterier till sändaren, Laddare, 2st 3S Li-Po batterier

Features:
Velineon VXL-6s Brushless Power System
VXL-6s Waterproof Electronic Speed Control
6S LiPo compatible
Built-in cooling fan
Machined heat sinks
10-gauge silicone wire
Velineon 1600XL Brushless Motor
"Big Block" brushless motor
4-pole 1600 Kv
5 mm output shaft
Aluminum slip-on heat sink
Easy to use mounting method
56+ KMH with two 3s LiPo Batteries
Traxxas Stability Management
Helps prevents spinouts and loss of control
Adjusts from off to 100% assistance from the Transmitter

TQi 2.4GHz High Output radio system:
Traxxas Link enabled (Bluetooth Wirelsess Link Module sold separately #426511)
TQi 2.4GHz 5-channel micro receiver (#6533) with fail-safe security and integrated telemetry ports
Automatically stores and loads settings for up to 30 Traxxas Link-enabled models-just switch on and drive, "model selection" is not required
Multi-Function knob
Adjustable steering and throttle percentage (dual rates)
Adjustable steering and throttle sensitivity (exponential)
Adjustable steering and throttle end points
High 13ms frame rate and near-zero latency for responsive control
Telemetry-ready 5-channel micro receiver with dual channel-1 inputs
BEC Voltage and Motor Temperature Sensors Installed

New body mount system:
Quick one-hand installation and removal
Uses pivoting rear latch mechanism
Eliminates body posts and clips

Drivetrain:
Full-time shaft-driven 4-wheel drive
All-steel CVD's
24 mm splined wheel hexes
Wheel hexes retained with a clip
17 mm hex on outside of wheel
Sealed, silicone fluid-filled diffs
Splined outdrives attached with external thru-bolt method
Heavy-duty fan-cooled slipper clutch
Fully machined aluminum stub axles
Splined aluminum center driveshaft

New motor mounting system:
Precision, preset gear mesh adjustments
No manual gear mesh adjustments are required
Motor retention separate from gear mesh

New modular composite chassis

Rigid Chassis Structure:
Modular chassis design interlocks with front and rear bulkheads
Motor mounts to rear bulkhead to eliminate gear crunching flex
Easy to service and access components
Driveline is sealed in the chassis to keep out dirt and grit

New battery retention system:
No body clips or hook and loop straps
Battery hold-downs pivot for easy access
Adjustable for battery size
More secure than conventional retention systems
Integrated into chassis top brace for improved battery tray and chassis stiffness

New steering bell cranks and servo saver:
New high-output steering servo
Wired directly into the RX box, no external wires seen on chassis
New mounting system to fully support case
Double-shear, bearing supported servo horn

Suspension:
Engineered to optimize suspension travel and steering angles
All critical suspension points have double shear strength
High strength steel suspension pins used throughout
Suspension pins retainers won't come loose or "back-out"
4 mm machined pivot balls
C-hub and steering block geometry maximizes steering angle
Adjustable roll center
Fixed, high-strength camber and toe links
Steel upper and lower tie bars
Full contact sealed bearings used in exposed locations

New GTX Shocks:
Machined aluminum threaded body
Extra-large bore and capacity
5.2 mm damper shaft
Lower seal cartridge includes integrated wiper seal combination
Adjustable upper spring retainer
Plastic shock caps with pivot balls
Fixed shock locations
Lower spring perches bolted on

Bumpers:
Front and rear energy absorbing rubber impact bumper
Lower front and rear skids for impact and abrasion resistance
Integrated nerf bars for side impact resistance

Wheels/tires:
8 x 4 x 4 inch all-terrain tires
Large, dual diameter wheels
2-piece foam insert
High-strength glue

 X-Maxx Truck Specs:
Length: 758 mm
Front Track: 540 mm
Rear Track: 540 mm
Ground Clearance: 102 mm
Weight: 8.66 kg
Height (ride): 350 mm
Wheelbase: 480 mm
Shock Length: 187 mm
Tires (pre-glued): 203 x 101.6 mm
Wheels: 110 x 145 mm
Speed Control: Velineon VXL-6s
Motor (electric): Velineon 1600
Transmission: Single-Speed
Overall Drive Ratio: 8.24 (stock, out-of-box)
Differential Type: Sealed, Hardened Steel Bevel, Limited Slip
Gear Pitch: 1.0-Pitch
Chassis Structure/Material: Composite Nylon Tub
Brake Type: Electronic
Drive System: Shaft-Driven 4WD
Steering: Bellcrank
Radio System: TQi™ 2.4GHz Transmitter with TSM receiver™
Servo Torque: 365 oz
Servo Speed: 0.17 s / 60° @ 6.0V
Top Speed: 56+ KMH with two 3s LiPo Batteries
Skill Level: 6
Battery Tray: 197 x 51.5 x 44 mm
Required Batteries: 4 "AA" (transmitter)


X-Maxx Motor Specs:
Type: 1600 kv Sensorless Brushless
Weight: 665 g
Length: 110 mm
Diameter: 48 mm
Connector Type: Traxxas 6.5mm Bullet Connectors


X-Maxx ESC Specs:
Input Voltage: 4s / 6s LiPo (Max 25.2 Volts)
Case Size: 47 x 60 x 41 mm
Weight: 140 g
Motor Connectors: Traxxas 6.5 mm Bullet Connectors
Battery Connectors: Traxxas High-Current Connectors
Power Wire: 10-gauge Maxx Cable

What's In The Box:
X-Maxx, Ready-To-Race® model with Traxxas Big Block™ brushless motor
VXL-6s Waterproof Electronic Speed Control
Quick Start Guide
TQi™ 2.4GHz radio system
High quality maintenance tools

What You'll Need:
Batteries - IMPORTANT: X-Maxx requires the use of LiPo batteries equipped with Traxxas High Current Connectors. Traxxas 3-Cell, 5000 mAh or greater, Power Cell LiPo batteries with iD are recommended
LiPo Balance Charger with iD (Traxxas model 2970 or 2972 recommended for easy and fast charging performance)
AA Alkaline Batteries (Four AA Alkaline batteries for the Transmitter)

Traxxas reservdelar - Klicka här!
Hur hittar man sin reservdel?
1. Hitta delens nummer på Traxxas supportsida
- välj din modell, ladda ner filerna med ritningar (Exploded views).
- notera delens nummer (4 siffror oftast).
2. Använd sökfältet på vår sida, så kommer du snabbt till den del du vill ha.
- Finns inte delen? Kontakta oss, så undersöker vi varför.

 



Typ Filnamn *
Finns inga dokument för produkten









Tillverkare

© GW Modellhobby AB, Org.nr. 556766-7398. Telefon 0500-60 00 88