Highly Integrated & Compact
The 4in1 ESC not only includes four high-performance 45A BLHeli-32 DShot1200 ESCs, two bulit-in BECs (5V & 10V) for powering FC (on VTX) and other devices, but also a voltmeter module which allows FC to monitor the battery volt & amp in real time. The XRotor Micro 45A 4in1 BLHeli32 6S with a small size (almost the same as a FC) is specially designed for competition FPVs.
High Quality Components
The use of high-performance 32-bit ARM MCUs with operating frequency of up to 48MHz, 3in1 drive ICs, top quality MOSFET & ceramic capacitors, 3-ounce copper, and 6 layers of PCBs guarantees less heat, higher efficiency and rapider response.
Innovative Shock-absorbing Structure
The innovative connecting method via a soft cable (it works better when pairing with the XRotor Micro-F4-G2 Flight Control) combined with the shock-absorbing design of mounting holes effectively reduces the impact on high-sensitivity ESC components from outside shock and provides great shock-absorbing protection to upper devises (i.e. FC).
BLHeli-32 FIrmware Ready
The XRotor Micro 45A 4in1 BLHeli-32 DShot1200, which features the 3rd generation of BLHeli-32 firmware, has great performance & rich functions and supports adjusting parameters or upgrading firmware via different methods (i.e. via throttle signal wire with using other development board or a FC flashed with the Cleanfight/Betaflight/Butterflight/Invaflight firmware).
DShot1200 Ready
Besides DShot150/300/600 digital throttle signal modes & the regular PWM/Oneshot125/Oneshot42/Multishot throttle signal modes, the XRotor Micro 45A 4in1 BLHeli-32 DShot1200 which features great anti-interference & rapid response also supports the latest DShot1200 super high-speed digital throttle signal mode.
Hardware Generated PWM & Damped Light Mode
The ESC firmware uses hardware generated motor pwm for smooth throttle response and silent operation. Damped light does regenerative breaking, causing very fast motor retardation, and it inherently also does active freewheeling.
Specifications
Cont./Peak Current: 45Ax4/60Ax4
Input Voltage: 3-6S Lipo
BEC output: 5V 1.5A / 10V 1.5A
Wires & Connectors
Input Wires: Red-12AWG-130mm / Black-12AWG-130mm
Output Wires: No wires but solder tabs
Input Connectors: XT60 (w/ Wires Soldered on)
Output Connectors: No
(Note: All the wire length above is the original length not the length you see from the outside.)
Features
Firmware: XRotor BLHeli-32
ESC Programming: BLHeliSuite
Stick Programming: Supported
DEO: Supported
Throttle Range Calibration: Supported
Oneshot125 Mode: Supported
Oneshot42 Mode: Supported
MultiShot Mode: Supported
DShot150/300/600: Supported
Timing: Supported
Motor Rotation: Supported
Size & Weight
Size: 46x40x6.3mm
Weight: 11.5g
Applications
130-300mm FPVs